Trail Stand By RideWithMe

Lightweight Trail Stand

by Ride With Me

Getting a flat on the trail is a big enough pain without having a way to hold your bike in the air to remove your wheels.

You can either fit a centre stand or add one of these to your kit.

Only 350 grams! They can come apart into two smaller sections for easier storage if necessary and are easily cable tied to your bike or even fit in your tool bag or panniers. Ready to use in moments.

To lift the front of the bike, insert the tongue of the stand into a suitable hole in your sumpguard, or utilise your crashbars or similar stable component.

Place the bike in full left hand lock with the bike in gear and push up on the bars to gently lift the front pushing the stand into an upright position with your foot. Of course you will need to adjust the length of the stand to suit your bike. To lift the rear of your bike there are two methods.

Another method is to attached the supplied small stainless steel ring to the bike just behind the foot peg at the lowest point possible. Hold the front brake on using the Velcro strip (supplied) and with the side stand down, move to the right-hand side of the bike and gently lift the bike pushing the stand into an upright position using your foot. The second method for lifting the rear of the bike is to place the top bracket of the stand directly under the swing arm or the foot peg however this is not as stable as using the small SS ring.

You only lift the bike high enough to remove the wheels. Always undo the wheel nuts before lifting the bike.

100% Made in Australia

Quality aluminum and fabricated by a qualified welder, this little unit will pay for itself with one flat tyre.

Includes:

1 x One stand

1 x Veclro for the front brake

1 x Stainless steel ring